Your start up guide says that when I plug in the trainer, I should see a blue light and hear a startup noise, but I get a green light and do not hear a noise. Is something wrong with my trainer?

Follow

Comments

2 comments

  • Avatar
    Fabregas Oriol

    I just bought an H2 and it paired a couple of times. The first time it got a linking blue light straight away when I started pedalling. The second time it took around 10 minutes to get a blue linking light. Unfortunately now it only blinks in green and can't pair it anymore. Any advice on how to reset the trainer or what to do? Thanks 

    0
    Comment actions Permalink
  • Avatar
    Mark Dee

    I plugged in my hammer 2 trainer this morning and noticed a blinking red light. Manual indicates that this would indicate the coil is over heated. I found that strange since I hadn’t had one rep yet. I followed the manual’s instructions to power cycle through this without any success. The firmware is up to date so what or who can fix the blinking red light (4/second)?

    0
    Comment actions Permalink

Please sign in to leave a comment.